Hot-Pressed Fine-Tooth Wave Diamond Cutting Disc for Stone & Tile

Diamond stone cutting saw blade are fixed in angle grinders with   high speed power.It could be used in block,concrete,pavers,brick and etc.And   the large diamond segments with cobalt provide an ideal combination for   cutting through even the toughest materials with exceptional accuracy.
Diameter	Segment Width	Segment Height	Arbor Hole
(Inch/mm)	(mm)	(mm)	(mm)
4″/105	1.7	5/7/10mm	22.23/20
4 3/8″/110	1.8	5/7/10mm	22.23/20
4.5″/115	1.8	5/7/10mm	22.23/20
5″/125	2	5/7/10mm	22.23/20
6″/150	2.1	5/7/10mm	22.23/20
7″/180	2.2	5/7/10mm	22.23/20
8″/200	2.4	5/7/10mm	22.23/20
9″/230	2.4	5/7/10mm	22.23/20
10″/250	2.6	5/7/10mm	25.4

Applications

This hot-pressed fine-tooth wave diamond cutting disc is built for cutting hard, brittle building materials when it is fixed on an angle grinder or other high-speed power tool.

• Stone slabs, natural stone and stone cladding for flooring, steps and wall finishing
• Tile and ceramic work, including straight cuts and edge trimming
• Concrete blocks and general concrete cutting on site
• Pavers, kerbs and paving stones for driveways and landscaping
• Brick, mortar and general masonry repair or renovation work
• Trim and finishing cuts where an accurate, controlled line is needed

FAQ

What materials can this diamond disc cut?

It is intended for stone, tile, concrete, block, pavers and brick. The large diamond segments with cobalt are made to cut through even tough materials with accuracy. It is not designed for cutting iron, steel or other metal.

What tool should I mount it on?

The disc is fixed in angle grinders and similar high-speed power tools, so it should be used on a machine that runs at the correct speed for the disc diameter and is fitted with a suitable guard.

What sizes are available?

Diameter, segment width, segment height and arbor hole are all listed in the specification table above, given in both inch and mm. The table shows the standard options; the diameter and arbor hole you choose must match your grinder and the material you are cutting.

What does the fine-tooth wave rim do?

The wave rim carries a fine-tooth segment pattern. Together with the hot-pressed diamond segments and cobalt bond, it gives a controlled cutting action for accurate work in stone and tile rather than a rough, aggressive break.

Can I use it on metal?

No. This disc is a diamond blade for stone, tile, concrete, pavers and brick. Cutting iron, steel or other metal requires a different type of abrasive product and should not be attempted with this blade.